Bride Seat Pattern Cotton

Cotton gradient set for 1/18 scale seats in classic Bride design

Printed on high grade fine cotton. Backed with 3M self adhesive tape. (optional)

Type 1 Universal

This is for 2x seats universal. For lower and back support surface on the seat.

Dimensions universal set, 2x below mentioned sizes are included:

• width per seat: 25.5mm
  
• height per seat rear: 33mm
• height per seat bottom: 33mm
• width delivered sheet: 51mm
• height delivered sheet: 66mm

Type 2 Bride Zeta 3 

This set is for 2x TK Diecast Bride Zeta 3 Seat Type 25 HERE

1 Set is enough for 2 seats,

Set includes 1 piece for lower support and 1 piece for upper back support surface. 

Dimensions before cut:

• width delivered sheet: 42mm
• height delivered sheet: 50mm

The set for the Zeta 3 seat has a red cut line printed on it for easier trace cutting.

How to Apply: 

To cut these cotton fabric sheets we suggest using the Scotch-Tape method to avoid fraying. 

1) apply a stripe of scotch-tape over the fabric

2) smooth out the tape on the fabric

3) with fine hobby scissors cut out the fabric (along the red line f.e.) 

4) remove scotch tape from fabric

5) remove protective sheet from self adhesive back

6) apply your piece of fabric to the seat and apply pressure to the surface evenly while carefully smoothing it out and pressing it into grooves. 

Optionally you can order these sheets without the 3M backing, for this you must apply your own glue and test what works best for you to the surface you are applying it to.

We advise to apply the cotton fabric piece carefully as the adhesive is strong and placing it again may be difficult.
We advise to use a non fluid/gel like glue to apply the fabric, any glue on a liquid base may be absorbed by the fabric and damage the gradient design. 

This listing does not include the displayed model or other parts. These are displayed as example purpose only.

This product is in 1/18 scale. For hobby use only.

© TK DIECAST